All of them as far as I know but double check. * Arbor: Arbor bindings are compatible with the Channel system. With all these different mounting systems you would think that it would be a difficult task to find bindings that are compatible with boards.įortunately most binding manufacturers create either universal discs that can be used on any system or they offer separate disks that you can buy to make your bindings compatible with a particular system.Ĭheck out the table and notes below to see brand compatibility. Your bindings also flex really well with the board because there is minimal hard contact between the board and bindings – meaning that there is virtually no dead zone.īurton EST bindings are designed to work with the channel system but most other bindings are compatible or have an optional disc that is compatible. You can also move the binding up and down width ways so that you can vertically align your bindings on the board. You can have virtually any stance width you want with this system. rail or channel) until they are in the desired position and then are screwed in place. Binding System #4: Channel Systemīurton’s current mounting system is the channel binding system. Bindings are attached to a track insert and then can move along the track (a.k.a. This system uses 3 screws to mount the bindings (in a triangular pattern). The first of the Burton systems is the 3D system. However Burton has used a couple of different types. Most snowboard brands use the first two systems (and mostly 2 x 4). However, if you buy and old Burton board it may still have the old 3 hole (3D) system. ![]() Binding System #3: 3-Hole (3D)Īll new Burton snowboards now use the channel system. This is the most common pattern for snowboards today. This allows for more stance width options than the 4 x 4 system. Similar to the 4 x 4 system except that the holes on the rows are only 2cm apart. There are usually 3 holes per row.īoth the 4 x 4 and the 2 x 4 systems use 4 screws for mounting bindings. Aptly named for the two rows of holes that are 4cm apart and there are 4cm between each hole on each row. The first is simply known as the 4 x 4 system. The exception to this is some cheaper boards and youth boards which often still come with a 4 x 4 pattern. This insert pattern is now very uncommon – most boards now come with the 2 x 4 pattern (or the Channel if a Burton board). Some systems will give more stance options than others in terms of stance width, angles and the position of the bindings across the width of the board. These pre-drilled holes allow you to screw your bindings into your board. By that I mean that there are different patterns of holes drilled where the bindings are to go. The 4 Main Binding Mounting Systemsĭifferent binding mounting systems have different insert patterns. The good news is that most systems are compatible with each other – and if not, you can often find base plate disc attachments that allow them to be compatible. ![]() Snowboard and binding compatibility is a really important part of finding the right bindings, for obvious reasons – getting bindings that don’t fit to your snowboard aren’t going to be very useful!īelow I will outline the 4 main binding mountain systems (2 of which are now not very common) used by snowboarding manufacturers and then show which brand’s bindings are compatible with which brands of snowboards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |